Model 536.886140... my question is... When the auger clutch is engaged should the belt be tight? I changed the belt and when the clutch is engaged the auger idler pushes against the belt however it is not very tight... I have adjusted the cable to the max point... any titer the auger runs by itself without the cable being engaged... so I would think its as tight as can be... any input would be greatly appreciated.. thanks!

Your idler (tensioner) should take up the slack. With a new belt, you should likely be loosening the linkage (because the old belt became longer). Look at your tensioner, it might just need to be freed-up with some penetrating oil, or need to be replaced.

Quote:

---

Originally Posted by scott53715

Your idler (tensioner) should take up the slack. With a new belt, you should likely be loosening the linkage (because the old belt became longer). Look at your tensioner, it might just need to be freed-up with some penetrating oil, or need to be replaced.

---

Hi Scott thank you for your reply.. I will check out these issues and hopefully get some progress... thanks again!