John Deere 14SB Mower
I am trying to remove the Blade clutch. I have removed the first half of it but there is what looks like a big washer holding the rest of it onto the shaft. How do I remove this?

Nathan

Some of these are threaded you can run a large bolt in the center and push them off.
If not you will have to remove engine and take it and have it pressed off,
I always tapped out the ones that weren't threaded then backed them out,if you have access to large taps you could do this.

Hi,
12mm x 1.25 pitch bolt in center
Peace,
Clarke