Why dose my furnace go out at night by its self and not try to start it seams like it could be a roll switch if I take the cover off then push the black switch in it works fine for a while again and then dose it again with in a day what could it be??

Sounds like the unit is "locking out", and removing/replacing the access panel is interrupting/ restoring power and cancelling the lockout. Does the unit have a status LED behind a clear viewer on one of the front panels? If so, observe and note pattern (if any) of blinks next time the unit locks out. Do so BEFORE opening front panel.

Quote:

---

Originally Posted by KC13

Sounds like the unit is "locking out", and removing/replacing the access panel is interrupting/ restoring power and cancelling the lockout. Does the unit have a status LED behind a clear viewer on one of the front panels? If so, observe and note pattern (if any) of blinks next time the unit locks out. Do so BEFORE opening front panel.

---

Thanks I will check that out the next time it goes out but what would make it lock out

thanks i will check that out the next time it goes out but what would make it lock out

Overheating,flame failure, are the two most common issues.

Quote:

---

Originally Posted by KC13

Sounds like the unit is "locking out", and removing/replacing the access panel is interrupting/ restoring power and cancelling the lockout. Does the unit have a status LED behind a clear viewer on one of the front panels? If so, observe and note pattern (if any) of blinks next time the unit locks out. Do so BEFORE opening front panel.

---

Hi you rember me my concord 80 plus went out again and the light blinks 6 times pause then 6 times pause then 6 times and keeps repeating do you know what that means

Quote:

---

Originally Posted by hvac1000

thanks i will check that out the next time it goes out but what would make it lock out

Overheating,flame failure, are the two most common issues.

---

My red led light blinks 6 times over and over what could that mean

Quote:

---

Originally Posted by hvac1000

thanks i will check that out the next time it goes out but what would make it lock out

Overheating,flame failure, are the two most common issues.

---

My red led light was also blinking 3 times over and over what could it mean

Check inside the access panels, or on the circuit board, for service legend.

Quote:

---

Originally Posted by KC13

Check inside the access panels, or on the circuit board, for service legend.

---

Well dident see no service legend but there is a diagram on back of panel what dose 3 blinks mean on the red light do I have to do a reset process or something

Quote:

---

Originally Posted by hoyster

well dident see no service legend but their is a diagram on back of panel what dose 3 blinks mean on the red light do i have to do a reset process or somthing

---

The concord 80 + is olny about 4 years old

Three blinks usually means pressure switch code, but if you look everywhere on the furnace the codes should be listed somewhere. Neve seen won without them. They would also be listed in your instulation manual if you have it.

Quote:

---

Originally Posted by Joshdta

three blinks usually means pressure switch code, but if you look everywhere on the furnace the codes should be listed somewhere. neve seen won without them. They would also be listed in your instulation manual if you have it.

---

Thank you