Quote:

---

Originally Posted by massplumber2008

Any plumber's grease will work...silicone grease is best!

Thank you for updating the numbers on the allen wrenches....I had a feeling I was off on the 1/4". I just changed it at my post above this one.

Good luck...and for what it's worth please note that Ballenger has 100s of hours posting to people on this site FREE OF CHARGE and that he is one of the most seriously dedicated people here. He was only trying to help...and in some way...he did..didn't he??

Don't be afraid to pop back anytime and share some information that you feel qualified to share with others here...;) That is what makes this place so cool!!

MARK

---

I'm guessing the 5/16" bolt can be used to simply "unscrew" the stuck diverter valve by turning the bolt until it meets the back end of the diverter channel.

I've done this and got the diverter valve 80% of the way out, but I think I need a longer bolt. I only used a 3" bolt.

Thanks for the informative posts above. It got me this far :)

Hey BBDINCT:

You use the 5/16" lag bolt to screw into the diverter spindle until it grabs well enough to put a pair of pliers on the head of the lag bolt and YANK the spindle forward... no need to go too deep. Be careful not to yank the valve out of the wall... ;) Hold against yourself when pulling and it will come out. You may even need to push forward and then try to remove again. These can be stubborn!


Good luck!

MARK