I have a goodman
Board number 1012-930 or B18099-05
The status light is off and the machine will not do anything.
I have 24 AC going to the board when the door switch is made.

Is there a print of the board or does the status light off mean its dead?

Is there a fuse? Just had a problem similar to that today and when I replaced the fuse and had the door switch made, the status light lights up. Mine was a 3 amp fuse.

Monster Buck is right you should measure across the Fuse with your volt meter it should read 0Volts AC if it reads 24 your fuse is Bad, if the fuse is good then the next is the rectifiers at wich point you might be better off replacing the board.

I had a similar problem. My status light went off and hpf wouldn't work so I switched it to lpf and it works juss fine but it doesn't hit as hard. What's the problem? I checked every wire and fuse in my whole system and everythin is juss fine except my status light and hpf doesn't want to work.