Now that I have removed the switch cover, I am now attempting to remove the wiring and put the new thermostat (ritetemp 6030). The problem is that I have 6 wires coming from the wall and the instructions don't have a 6 wire heat/pump - aux heat wiring schematic. The show a 5 wire schematic but that leaves the black wire that is currently connected to the X1 spot without a connection. There isn't a X1 connection on the new thermostat either. The connections on the new thermostat are from L - R:
C B O W2 W Y Y2 RH RC G A

What are the terminal designations on the old thermostat? Left to right does not matter.

y g r w2 x1 o

Wire as follows (old-new): R-Rh (with jumper to Rc), W2-W, Y-Y, G-G, O-O, X1-C. Remaining terminals unused.

Thanks again. You have been very helpful.

Your welcome. Give us a full report when you're done.

OK. I wired it per your instructions. The jumper positions are a bit confusing, I am also not sure how to jump the rh to rc. (a small wire from one terminal to the next?)

Usually the thermostat will come with a jumper already present between Rc and Rh. If not, simply add one with a small piece of wire. Are there other jumpers you are unsure of?

There is no jumper already there between Rc and Rh. The instructions refer to jumper settings for either a oil heater or electric. There are connections next to the wire connecting points. They are numbered 1 - 5, with 1 &2 on left and 3-5 on the right. They have what appear to be either a purple or black plastic fuse like looking plug in each spot. The instructions refer to the jumpers but it doesn't explain it very thoroughly.

Thanks again.

Here is the install guide for the Rite Temp 6030 thermostat

http://www.ritetemp-thermostats.com/...tion_guide.pdf