From my earlier post ignite for a few seconds the stops, now, heat commanded, blower motor runs, no ignition, and flashes code 22
Help!

What earlier post?? Please keep all threads together so the questions can be followed.

Hi,
So Sorry,
I posted a question earlier, wherein when commanded, fan would ome on, unit would ignite for about 3 seconds, then quit.. fan & flame, Unit will then keep repeating this procedure. All the while this is happening, red LED is just a continuous flash. After a while, the fan would come on, and unit would not ignite. While this was happening, LED was flashing a code 22. I turned off main power to the unit, checked a couple of things, and when I re-powered the unit, it goe back to the... heat commanded, fan on,ignites for about 3 seconds, the both quit,, repeat. At that time, you suggested a dirty flame sensor. I will check that,and post my findings.
I truly appreciate your help, and you fast response to my posts, You are a huge help.

If the posts are not together I usually cannot follow the discussion.

Hello again,
I cleaned the flame sensor, and all is well! Thank you so much for your help.. You people are GREAT!
Regards, John

Glad you got it going.