Was running and stop. Chev engine. Spray Quick Start in opening of Carb still would not start? I think I am getting gas to the Carb anyway to check for sure. Thanks Paul
![]() |
Was running and stop. Chev engine. Spray Quick Start in opening of Carb still would not start? I think I am getting gas to the Carb anyway to check for sure. Thanks Paul
Check all the fuses and check for spark.
Thoroughly inspect the ignition system for corrosion.
Check both ends of both battery cables, making certain they are clean, tight and free from corrosion.
Let us know.
Thanks What's the easy way to check for a spark? This might be my problem starter turns over good . Also wondering if I choke it too much and flooding out spark plugs? Thanks Paul PS It was running good until engine stopped And could not restart?Quote:
Originally Posted by CaptainRich
Easiest? Remove the high-tension coil wire or plug wire. Insert a screwdriver into the wire end and hold it near the engine to simulate the sparkplug gap (roughly 1/8" should be adequate for test purposes) while cranking the engine over. You want to see a strong blue spark snap across the gap. Excersize caution - if spark is present, immediately stop. It is possible if you've attempted to start the engine, it may be flooded. Can you smell fuel, either during or after cranking?Quote:
Originally Posted by olesuds1
Did the engine stall and then not restart, or was it turned off and then not restart?Quote:
It was running good until engine stopped And could not restart?
Thanks for your quick responds The engine was running stopped and I could not restart. Only smell a light smell of gas.. Right now here in Reseda Ca its to windy and cold and rain coming in to check it out now and will let you know later.Many high fives and thanks for your help.. PaulQuote:
Originally Posted by olesuds1
You may need an ignition coil and/or ignition module.
These are difficult to diagnose without proper test equipment and experience in this area.
All times are GMT -7. The time now is 10:56 AM. |