Do I HAVE to Dig and Bypass my Grease Trap?
Our brick ranch house in the Denver area was built in 1952, and until recently we never knew it had a grease trap. The kitchen sink started running slow and our drain cleaning guy said the grease trap was near full and the best thing to do would be to locate it, (probably just outside the house in the perennial bed, possibly under the front walk) dig down, (through sprinkler lines, etc) and re-route the plumbing to bypass the trap, for a total cost of around $1200 - $1800 and a lot of trouble to repair the damage to landscaping, etc. In case it's relevant, the kitchen drain line goes straight out the front of the house, through the trap (we were told) then connects with the main line before it dumps into the main sewer line in the street.
1. Is it too late to use bacteriological products to digest the grease/sludge or whatever is in there? We would stop using automatic dishwasher soap with bleach and continue to minimize stuff put into the garbage disposal.
2. Are we wasting our time trying this because the grease, etc, already in the trap has solidified over the years and will never break down? If we keep introducing bacteria, will it likely chip away at this buildup until we no longer have a problem?
3. Are we better off just to bite the bullet and go through the hassle and expense of digging up the front yard?