Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cracking drywall where a previous owner removed a load bearing wall
[ 2 Answers ]
My house was built in 1960. In 1979, a previous owner remodeled the kitchen, removing two walls to open the room up. The kitchen is at the front of the house, with the stairs to the basement behind it, and then the dining room is on the back of the house. The owner removed the walls on either side...
Something that will stick to a brick wall, that can be removed & reused, like velcro
[ 4 Answers ]
I am looking for something that can be used to hang on a brick wall that can be taken off and re-used on different walls and different areas. It would work like a magnet but on brick.
Wall above wall I want to removed
[ 4 Answers ]
Hello, I have a 1960's tri-level. The Lower level is 25' x 25' on slab and block. A ledge steel beam divides the room that run perpendicular to the floor joists support by a steel column (in the middle) and block on the ends that supports the upstairs wall. I want to remove 13' of a 25' wall...
Removed supporting wall - please give advice re: property assessment?
[ 1 Answers ]
Hello, I am considering purchasing a century-old property in which a load-bearing wall between the living room and dining room on the first floor has been removed. I have been told that the second floor is bowing as a result, but I do not have any measurement of how much it is bowing. My...
Removed switch, hole in wall plate
[ 3 Answers ]
Hi, I removed a switch from a circuit inside a 3-gang box. Now I have a hole in my switch plate. I'm assuming there's something I can find that will be a kind of "dummy switch" and basically cover the hole in the switch plate from the inside. Does anyone know if such a thing exists, and if so... View more questions Search
|