Ask Experts Questions for FREE Help !
Ask
    jrcon's Avatar
    jrcon Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 8, 2007, 03:35 PM
    Carrier Furnace / AC Electrical Issues (Burning Plastic Smell)
    Hello All,

    Any help would be greatly appreciated, as I am a bit of a novice in this area. I have a Carrier 58GS100-GA Furnace & Carrier 28RC130010 AC unit on top. Just today I noticed a strong acidic burning smell coming from the basement and loud humming sound, and noticed some minor smoke collecting in the basement. I quickly switched the thermostat to off, and master pwr off and proceeded to investigate... Pulled the maintenance cover and looked for burnt electrical lines but could not find any. So I decided to turn the thermostat back on and then set a temp (AC), went back down to the furnace and flipped the master pwr back on then depressed the furnace blower door safety switch back on and noticed a blue electrical flash *POP* just behind the box for the that switch. I repeated this a second time, and saw another flash came out from behind the blower where the lines came out of the switch box and went to the back lead behind the blower. I did notice the blower turns fine, both manually and after startup (continued to work until powered down, after the electrical flashes). I turned all power off again, and searched all the lines and could still find no burnt wiring. Any ideas? Thanks a lot!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jun 8, 2007, 08:05 PM
    I believe the blower motor is shot or the wiring has rubbed through and shorted. If you do not know exactly what you are doing I would call for service. You might also have them check the door switch since you flashed it a few times during your testing and they are known to go bad when they flash. The smell is probably from the motor windings burning. The name of that smell is askrill.
    eagark's Avatar
    eagark Posts: 14, Reputation: 3
    New Member
    		  
    #3

    Feb 10, 2008, 01:28 AM
    My vote goes to the blower motor giving its last as it usually goes out with a strong smell. Usually an amp test will reveal a weak motor, but often it just burns up and eventually quits
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Burning plastic smell when water is running - please help [ 5 Answers ]

Hello, I posted a question earlier about smell from hot water, well it is in the cold water too and it definitely is NOT a sulfur/rotten eggs smell. The smell is a distictive burnt plastic smell and now is with hot and cold water. Please help! Thanks in advance, Rachel

Washing Machine Electrical Burning Smell [ 2 Answers ]

Greetings, Here's the long and the short of it. My Daughter pulled the drain plug out of the washing machine (found at bottom front of my European Zanussi Washer/Dryer combo) during a wash and water went everywhere. The only way I could see to reinstall it is by putting the machine on its side...

Burning smell [ 1 Answers ]

I woke up this morning to a burning smell coming from heat vents. I can't see anything burning and I changed out the filter already. It smells like plastic.

Burning Smell Associated with Light Switch [ 2 Answers ]

I have one light switch that frequently produces a burning smell when turned off (although the light plate is never warm to the touch). The light switch is not particularly old, but wasn't replaced yesterday either. I have had this problem in apartments I have lived in in the past, although this...

View more questions Search