Blower not working

bjh4177 Posts: 1, Reputation: 1

New Member

May 30, 2007, 06:26 PM

Blower not working

Blower/fan will not turn on, replaced the transformer, but not the answer any ideas

letmetellu Posts: 3,151, Reputation: 317

Ultra Member

May 30, 2007, 08:45 PM

What blower fan are you talking about. The one in the furnace or the one in the AC unit?

sampsonsix Posts: 2, Reputation: 1

New Member

Dec 5, 2007, 06:45 AM

Furnace

Add your answer here.

Check out some similar questions!

Blower not working with Heat- OK with AC [ 2 Answers ]

I have a recent HVAC system and not too long ago I had to remove the blower and lube the bushings because it had frozen. This was with the AC Now, that's its cold and we turned the heat on the blower either comes on for a bit and then quits or doesn't come on at all. I can turn the AC on and the...

Blower not working in AC mode [ 1 Answers ]

Blower for AC unit stopped working, the condenser unit is working outside. When switched from automatic to manual mode on thermostat the blower does not come on either. Set thermostat on the heat mode and the blower motor did come on. Any ideas?

Blower not working [ 3 Answers ]

I've got a Rheem Furnace which has the blower in it. The blower is also hooked up to a Trane AC unit. The blower does not come on but I hear a buzzing noise coming from either the transformer, or relay. I figured it was either the relay or capacitor and replaced them both for about $25. The motor...

Blower on top of heat pump not working [ 1 Answers ]

I have a Coleman heat pump that is less than 2 years old and has worked well up until a couple of days ago. Now, the air conditioning and the heat will not work, but the fan and furnace still works. After checking things out myself for small problems with the electrical box, etc, I noticed that...

Blower fan not working [ 2 Answers ]

I have a York central a/c forced air gas furnace. It's about 10 years old. The blower motor has stopped working. I can spin the squirrel cage freely by hand. Everything else seems to work as it should. Using a multimeter, as far as I can tell (I'm a plumber, not an electrician) 120V is not being...