Ask Experts Questions for FREE Help !
Ask
    cavale's Avatar
    cavale Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 24, 2007, 02:18 PM
    Craftsman 21' Lawn Mower Belt Replacement
    I am trying to replace the belt on my 21" 7hp Craftsman which split and I can't seem to find a diagram for repair. Any suggestions? I tried to find the donwload section on the Sears/Craftsman site, and was not successful.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    May 24, 2007, 03:28 PM
    This must be a very old machine, I haven't seen a 21 " tractor from Sears in 20 years. WShich of the three belts broke blade, drive or deck?
    cavale's Avatar
    cavale Posts: 2, Reputation: 1
    New Member
    		  
    #3

    May 25, 2007, 04:08 PM
    It is a push lawnmower and it seems to be the only belt
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Diagram for replacing lawn mower belt on Sears Craftsman 4000 Riding Mower [ 9 Answers ]

I need a diagram on how to replace a belt on the Sears Craftsman II 4000 riding mower

Craftsman 30" 13.5 hp riding mower drive belt [ 1 Answers ]

Thank you, Please advise the technique in the removal and replacement of the clutch drive belt on this craftsman riding mower, model number 536270211. (Same as Murray Mower.) Thanks Steve

Replacing drive belt on Craftsman riding mower [ 1 Answers ]

How do I replace the drive belt on a 125HP, 38" mastercraft riding mower?

Craftsman lawn mower [ 1 Answers ]

My father has purchased an old lawn mower for restoration. The model # is 1318430. He thinks it is a Craftsman. Anyone know where to find a picture or details.

Deck belt for craftsman 15.5 riding mower [ 1 Answers ]

I have a 8yr old craftsman riding mower with a 42in deck I went to get a belt and I got the right one but I can not get it to go on do I need to remove any of the pullys or are there any tricks that I need to know or should it just go right on it is about 3inches to small. And I did disengage the...

View more questions Search