Ask Experts Questions for FREE Help !
Ask
    troypt's Avatar
    troypt Posts: 19, Reputation: 1
    New Member
    		  
    #1

    May 24, 2007, 12:25 PM
    Replacing icm on 92 civic lx
    I need to put a new ignition control module in my 92 honda civic lx. I have never done this before and I just need to know how I go about it. How hard is to do? I know its in the distributor but what else do I need to know? Thanks for your expertise!
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    May 24, 2007, 12:45 PM
    If you follow these instructions, you should not have any trouble:

    https://www.askmehelpdesk.com/cars-t...tml#post265896
    hiperf402's Avatar
    hiperf402 Posts: 106, Reputation: -1
    Junior Member
    		  
    #3

    May 26, 2007, 08:52 PM
    Holy Hell. Here are my directions.1 pull the distributor out.replace igniter.reinstall. If you can't do that than go to txgreasemonkey's house for krumpets and tea and he'll show you.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

ECU input to Igniter (ICM) on 1993 Honda Civic DPFI [ 0 Answers ]

How do you measure the input from the ECU to the ignitor (ICM) (YEL/GRN wire)?? This input tells the ignitor when to ground the -ve side of the primary coil. My multimeter registers a non zero small voltage when cranking, but since the response is very low on my meter, I don't think I'm...

My sons 91 Civic will not start after replacing rad. [ 7 Answers ]

My son bought a second hand civic. It needed a new rad and thermostsat. My friend and I replaced them and the car ran great... until I had to put it back in the garage and now it will not start. The battery is great, car has gas but still will not start. We didn't do anything but the rad and...

95 HOnda Civic won't start - suspect ICM [ 1 Answers ]

My 95 Honda Civic won't start. Cranks good. Injects fuel (removed injecters and cranked engine - nice spray!). Appears to get spark (spark plug wire with old spark plug to ground for all 4 cylinders - somewhat weak). Tested compression and all around 150 psi. Tested distributer according to Haynes...

View more questions Search