Ask Experts Questions for FREE Help !
Ask
    FRANK eDWARDS's Avatar
    FRANK eDWARDS Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 19, 2007, 11:10 AM
    Where can I buy a Honneywell circuit board ST9120C
    Where can I buy a Honneywell circuit board ST9120C
    Fr_Chuck's Avatar
    Fr_Chuck Posts: 81,301, Reputation: 7692
    Expert
    		  
    #2

    May 19, 2007, 11:51 AM
    Here is a couple place, if you merely place the part name in a Yahoo search dozens of places pop up.

    Furnace Fan Timer # 1170063/ST9120C 5013

    https://keithspecialty.com/hvac.parts.Honeywell.htm
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

3-amp fuse on circuit board [ 7 Answers ]

I've been having an intermittant problem where the 3-amp fuse on the circuit board keeps burning out. Lately, the problem has occurred in the late afternoon (3-7pm) such that when I replace the fuse, it will last for 3-4 minutes before blowing again. If I wait until late in the evening to turn on...

Turning on A/C blows 3amp fuse on circuit board [ 1 Answers ]

Hi, Hope someone can help me. As stated in the title, when ever I turn the a/c on it blows the 3 amp fuse on the board. The system works fine with heat on. It's only when I activate the a/c does it burn. I have no idea what is causing the fuse to blow. Does anyone have any ideas of where I can...

Which Air Handler Circuit Board Wiring Diagram? [ 2 Answers ]

Had a new Heat Pump installed earlier this week by an independent. Guy did a decent job but I found a fault in the air handler wiring so now I'm second guessing this whole deal. Outdoor unit is a Goodman GSH140421A (3.5 ton) Indoor unit is a Goodman AEPF42601 w/10K heat strips After the...

Help Replacing Carrier Circuit Board HK42FZ004 [ 2 Answers ]

I have a Carrier gas furnace that is not getting gas; the rest of the cycle runs properly, including the HSI glowing, but there is no gas to light, so the system shuts down and I get a 21 error code (gas lockdown). I am showing no voltage to the gas valve at the point in the cycle when control...

View more questions Search