Ask Experts Questions for FREE Help !
Ask
    dodgehemi1's Avatar
    dodgehemi1 Posts: 8, Reputation: 2
    New Member
    		  
    #1

    May 7, 2007, 05:07 AM
    Put in gear it takes about 30sec. Before it moves
    I have a snapper rear motor 12.5 horse it will" not" take of in the low forward . But I can put it in high gear it will take about 30 sec before it takes of. Reverse is fine. What do I have to do to fix this ? This is a 79 model ,
    newaukumdon's Avatar
    newaukumdon Posts: 525, Reputation: 44
    Senior Member
    		  
    #2

    May 8, 2007, 11:35 PM
    There is a tension spring that holds the drive disc tight to the variator pulley. It may be missing or the variator pulley bearings are bad. Variator (dinner plate) Drive wheel (disc with rubber band)

    Don
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Forced Air Furnace flame good, fan goes slow then fast then slow, etc [ 1 Answers ]

Hello, I have a forced air propane furnace in a "Park Model" rv trailer. (This is a bit smaller than a mobile home) The furnace is used infrequently as the trailer is located in a sumer resort vacation area, however we do like to go up a couple of times in the winter months. Furnace was...

14 hp murray will not go in gear [ 1 Answers ]

14 hp murray trnsmission will not engage. I can push it in any gear while off. Will not engage when on. Thanks

Nfl gear [ 1 Answers ]

On TV, I see a band around some of the players arms, they are like elastic bands, what are these bands? What r they used for?

View more questions Search