Ask Experts Questions for FREE Help !
Ask
    classicbob's Avatar
    classicbob Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Apr 22, 2007, 09:53 AM
    Toro Lawnmower Pull Cord
    How do I replace my pull cord on my Toro Recycler Lawn Mower. It appears to have rivets holding it down. Do I really need to unscrew the entire enginge?
    newaukumdon's Avatar
    newaukumdon Posts: 525, Reputation: 44
    Senior Member
    		  
    #2

    Apr 22, 2007, 11:39 PM
    Quote Originally Posted by classicbob
    How do I replace my pull cord on my Toro Recycler Lawn Mower. It appears to have rivets holding it down. Do I really need to unscrew the entire enginge?
    Years ago they spot welded where you see rivets and people would continue to look because they Knew there had to be another securing method, now with those stupid rivets people see them and say "not gonna drill out rivets" and quit. There are 2 bolts on the front oppsite side of engine from spark plugs. And there is one above the plug (maybe 2, one above and left and one above and right.

    You will remove flywheel housing and acces it that way.

    Don
    OHara's Avatar
    OHara Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Jul 6, 2010, 12:31 PM
    It does have rivets holding it. All plastic has to be removed and then 4 screws hold on metal recoil housing.
    MONSTER80's Avatar
    MONSTER80 Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Sep 3, 2012, 07:57 AM
    That was helpful
    MONSTER80's Avatar
    MONSTER80 Posts: 2, Reputation: 1
    New Member
    		  
    #5

    Sep 3, 2012, 07:58 AM
    That was helpful.. thanks you
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I can't pull the starter cord on my 10hp Briggs and Stratton Engine [ 6 Answers ]

I recently purchased a two year old 10 hp Troy Built wood chipper. I've used it for about 4-5 hours and recently had to add a little oil. I added the correct type as per the manufacturers instructions. It started up just fine and after 15 minutes or so I shut it off to empty the bag. Once the...

Pull cord won't pull on Murray 2.0 mower [ 7 Answers ]

I have a Murray/Briggs 6.0 engine mower and the pull cord is sticking. It will stop after pulling about 4 inches. Then if I jiggle the pull cord it will extend another 4 inches. I can see a plastic piece that seems to be stopping it at every four inches. What is causing this and what is the repair...

Toro pull starter [ 2 Answers ]

Toro recycler pull start pulls almost all the way out before engageing the engine to start. How do I repair?

Pull cord light switch [ 1 Answers ]

I pulled the cord from my pull cord light switch. What should I do? Do I have to replace the whole fixture or can I replace the cord? OHH!! Before I forget the cord is totally pulled out. There is no cord visible. I haven't take the fixture off Thanks for all the help:confused:

View more questions Search