Ask Experts Questions for FREE Help !
Ask
    RD Anderson's Avatar
    RD Anderson Posts: 2, Reputation: 1
    New Member
     
    #1

    Apr 20, 2007, 09:49 AM
    Low water pressure
    Hi all,

    I have problems with low water pressure in my home. My home was built in 1933, stick-frame two-storied, upstairs / downstairs are supplied by a common water heater and water service, outside the house water pressure is fine. Where I run into a situation is at the kitchen, bathroom sinks and the shower.
    On the first floor kitchen sink, cold water pressure is good, hot water pressure is a trickle, first floor bathroom sink hot and cold pressures are just a trickle, shower on the first floor suffers the same low-pressure trickle as the bathroom sink. (FYI, it takes 18 minutes to fill a five-gallon container at the shower, bathroom and kitchen sink.)

    Second floor, kitchen sink pressure is low on both hot and cold faucets, bathroom and shower have good pressure.

    One mitigating factor that was mentioned to me is the plumbing in the house is all galvanized pipe. I've been told that could be the root cause of my problem, and the low pressure / good pressure mix could just be blockages at the faucet.

    I can't afford to be wrong on this and start diassembling the plumbing and leave my family without service.

    Where should I start? Your thoughts.
    My family would be grateful.:D

    Thank you,
    RD Anderson
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Apr 20, 2007, 09:59 AM
    Chances are very good that much of your piping is almost closed off with scale, lime, calcium. 75 years is a long time for galvanized pipe in most areas. Before you start taking the house apart you should test the pressure at your meter to make sure the problem isn't the main.
    doug238's Avatar
    doug238 Posts: 1,560, Reputation: 62
    Ultra Member
     
    #3

    Apr 21, 2007, 05:43 AM
    You are going to have to repipe.
    RD Anderson's Avatar
    RD Anderson Posts: 2, Reputation: 1
    New Member
     
    #4

    May 11, 2007, 08:11 AM
    Is there no other solution? What about a solvent to dissolve the deposits?. then flush out the pipes.
    The city replaced the main three years ago, and the unit is working fine.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #5

    May 11, 2007, 12:45 PM
    Quote Originally Posted by RD Anderson
    Is there no other solution? What about a solvent to dissolve the deposits?.....then flush out the pipes.
    The city replaced the main three years ago, and the unit is working fine.
    The only solution to old clogged galvanized piping, I'm sorry to say, is to replace it and repipe. The reason I'm sorry is that I'm faced with the same problem in my 53 year old home. Looks like we're both going to hafta bite the bullet and repipe. I'm thinking plastic. How about you? Regards, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water line replacement = entire house low water pressure [ 3 Answers ]

I recently had a water line break in my front yard. The city replaced the line but ever since (immediately following the water being turned back on) the water pressure has been significantly lower throughout the house in both the hot and cold. I checked and the valve is completely open so I am...

No water to both sinks / very low cold water pressure to bath and washer [ 1 Answers ]

My kitchen and bathroom sink have no water, period. Hot water seems to be pretty good to the bath and washer but cold water to those 2 locations are very weak. The outside faucet is very weak at best. I have had this problem for quite some time so it's not the fact that they are frozen. I just...

Low water pressure oil hot water heating system [ 1 Answers ]

How does one go about increasing water pressure in a baseboard heating system?

Low Pressure and Low Flow Water Supply [ 4 Answers ]

I recently moved into a house that is about 6 years old. The house sits upon a small hill. The water pressure is 40 psi at the street and the flow rate is 13 gpm. At the house, the pressure is about 30 psi and the flow rate is 3.5 gpm. The house is higher than the street level, but the...

Low water pressure in an area known for high pressure [ 3 Answers ]

Greetings, My wife and I are in the process of updating 1957 side by side split level. The previous owner (OK, my Mom as I bought the house I grew up in from her) said that when they moved in they had to install a pressure reducer into the line. I have searched high and low but, I can't see...


View more questions Search