 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
https://www.manualslib.com/manual/18...Ultra-105.html
Start at page 29, 02 code - Ignition failed 5 attempts (TWO categories) |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My Weil McLain Ultra 105 boiler has been kicking code 18 for several years. No tech has been able to find the problem. All known sensors have been changed. The circulator pumps have been changed. The boiler temperature has been adjusted to 180 degrees. It continues to lock out on code 18
I am considering a Ultra 230 boiler and in looking over the documentation I have three questions: 1. What the heck is a "condensing" boiler? 2. Will this boiler system work with cast iron radiators? 3. The piping diagram shows a 12" long connection atop the boiler between the input and...
My Ultra-155 locked out with a blower fault. If I remove the connector with the control signals the blower takes off. When I put it back in, the fan stops. My signals from the U-Control show blower out = 0 and RPM in = 0. V+ to V- is about 40 volts. Can this be fixed? If not is the problem...
I have a Ultra 155 boiler with an indirect 40 gal DWH. 4 zones, plus prioritized domestic water Taco switching relay. The system uses 4 taco cartridge circulators for the four zones plus one for the DWH. It constantly goes off (at least once every other week in the winter) on a too much flow...
My Weil Mclain Ultra 80 Boiler display shows a hard lockout code E12... Pressing the reset button does nothing... ie the display will not then change back to the normal standby or operating mode... Removing the thermostat wires and then jumpering the thermostat terminals 5 and 6 on the low...
View more questions Search
|
