 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
York XYF8V080AU3LAB GAS Heater no flame
I put a voltage meter on the gas valve and am reading 0 volts between the black wire and common and 9 volts on the yellow wire to common. The igniter heats up but no gas. After three attempts the heater shuts down. I am getting error code 7, which per the manual states: low gas pressure/faulty gas valve/dirty or faulty flame sensor/faulty surface ignitor. Because I have good gas pressure and igniter. Is this a problem of the mother board or the gas valve? How can I check the gas valve and the flame sensor? Is there a resistance that should be at the ignitor. I am reading 0.3 Mohms.
|
||||
|
||||
|
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
My furnace starts and the ignitor (new) lights up followed by a click, but no flame. It will continue running and blowing cool air and the ignitor will light up every so often and then the click again, but no flame.
I turn the heat on the thermostat to the automatic heat position, and the furnace will lite for about 5 seconds then goes out. When I turn the power off and turn it back on, the furnace will once again come on for about 5 seconds then go off. The entire time the fan is running, even when the...
No other symptoms as to why gas won't cut on, no signal for gas
I have a York Stellar Furnace The Model Number is ( P3UCd20N09101A) I can not get the flame to stay on, Therefore I am heating my house with the oven . I have cleaned the Temperature control stick, Gas is on, Thermostat is digital and has new batteries, and the filter is brand new. I have...
View more questions Search
|
