 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Vulcan CX90 furnace won't switch on
I've moved the thermostat to another location, in doing so I did not disconnect power to the unit and fear that I may have shorted some of the six wires and damaged a circuit board. I heard some relays engaging when I pulled the thermostat wires thought the wall. I've checked the thermostat with my neighbour's (similar unit) and it works fine. All fuses all OK. Pilot light is ON. I have the right voltages at the thermostat terminals. Any ideas where to look will be much appreciated.
|
||||
Check out some similar questions!
The programmable thermostat on our Vulcan CX90 ducted gas heating system has died. A gas plumber has checked out the furnace, which is working fine, but he was unable to replace the programmable thermostat as they are no longer available. Tradelink advise that it can be replaced by a Honeywell...
Wiring diagram
Hi, I'm trying to install a Honeywell Focus Pro 6000 controller to a Vulcan CX90 Ducted Heating Unit. There are 6 wires coming from the CX90 marked A,B,C,D,E & F. The wiring diagram for the CX90 is no help because all 6 wires disappear into a decoder unit. Can anyone offer any help on wiring...
Hello I have a Tempstar/Keeprite furnace model HGF120NE-1, Serial number 8464124770. (the exterior of the furnace has Tempstar logo and interior of furnace has Keeprite logo.) This furnace has an intermittent pilot light system. At times, especially in the morning after allowing a...
I originally had a bad tranny when I brought this bike. Long story. Anyway I rebuilt it and installed new gears on the tranny and a new shift drum. I put everything back correctly and before starting it went to put it in neutral and no movement. When I installed the tranny in the case it was...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
