Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Weed eater featherlight, primer bulb
[ 8 Answers ]
I have a weed eater feather light that will not run. The primer bulb has a sizable crack in it but I'm still able to make it prime but it won't run. Is the crack in the primer bulb keeping it from running or do I have another problem? Also, does anyone have a link for weed eater parts? The...
P-trap GAP - p-trap too low to meet sink drain extension
[ 13 Answers ]
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all...
Primer bulb for push mower
[ 3 Answers ]
I have a push mower that only stays running when the primer bulb is pushed in. When I let go of the bulb, it quits running. Does this mean there is a hole in the primer bulb. When I hold the primer bulb in it runs like it would normally. Any suggestions?? :confused:
P-Trap
[ 1 Answers ]
I have a townhouse with a rough-in for a shower in the basement. Would the rough-in already have a p-trap in the drain-line. Is there any way to verify if it exists? Thanks
Trap
[ 1 Answers ]
I am installing a drain in my laundry room floor. What type of trap should I be using. The trap will not be getting normal use like a sink would. My fear is if I use a normal trap it will have a smell to if because lack of water running on a daily basis. View more questions Search
|