Ask Experts Questions for FREE Help !
Ask
    ebfbburg's Avatar
    ebfbburg Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 13, 2016, 11:41 AM
    What makes hydraulic fluid spew out of the reservoir at the tap bolt where you put it
    I have a duerr 22 ton log splitter. What makes the hydraulic fluid spew out of the reservoir at the vent bolt where you put the fluid in. Thanks EB
    cdad's Avatar
    cdad Posts: 12,700, Reputation: 1438
    Internet Research Expert
    		  
    #2

    Feb 13, 2016, 07:54 PM
    One thing could be if it is overfilled. Also are your vents clean on the tank ?
    ebfbburg's Avatar
    ebfbburg Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 14, 2016, 11:00 AM
    It is about an inch below the top of tank. Vent is clean
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hydraulic fluid for a Duerr splitter? [ 0 Answers ]

Hi folks, I too have a Duerr splitter, model Pro/20 (I believe). I was wondering if anyone knew what type of hydraulic fluid to use or is there a specific viscosity recommended? thanks!

Bathroom cold tap makes a loud noise when turned on [ 3 Answers ]

Hope some one can help. I have just had a new main pipe laid through my driveway due to a leak. Now when I turn on the cold tap on in the bathroom it makes a loud thumping noise, but not all the time and not always the 1st time I turn the tap on. This morning I turned it on and it was fine and then...

Brake fluid reservoir cap slightly lose [ 3 Answers ]

I own a 2003 honda accord ex 2.4 automatic. I was wondering if the brake fluid reservoir caps on these cars have a slight wiggle to them even after being clicked into place?

Pressurized Hydraulic Reservoir on Wood Splitter [ 3 Answers ]

My Log Splitter is building pressure in the hydraulic reservoir, when the unit is running, And it is blowing out the air vent off the reservoir, making a mess, I also noticed that my \ Oil seal on the hydraulic pump is leaking now? Is the pump sucking air in, causing pressure to build in the...

Where do I put the transmission fluid in a MB 500SEC? [ 2 Answers ]

Hello: I need to know where to add transmission fluid to a 1984 500SEC mercedes. I believe it may go in the same place as the dipstick to check the transmission fluid (red cap), but I need to be sure. Also, how much fluid should the vehicle have? I see there are 2 lines on the dipstick,...

View more questions Search