 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
White rodgers 50a50-241 8 flash error code
I have the White-Rodgers model 50A50-241. If I set the temp at, say, 68 degrees, the unit will heat to that temp. and then the blower stays on blowing cold air. I believe I'm getting error code: 8 (flashes). Do I need a new control board?
Thanks. |
||||
Check out some similar questions!
I have a York Furnace natural gas with a white rodgers 50a50-241 board, After no heat just blowing cold air I shut off the system let it sit for about 5 minutes and turned back on... worked fine for 3 days. Now it give me 7 flashes from the board after 3 tries at lighting on its own. Ignitor burns...
I am installing a wifi thermostat which requires 24 volts, normally labeled"C". Where is the C terminal on this board?
Hi My Luxair with white rogers 50a50-241 control when running the fan in manual for A/c sometimes the fan seems to puslate like trying to start , if I shut it down and let it rest it seems to be normal. Could the run cap be bad?
My furnace is intermittently not starting. It is an Amana with a White Rodgers 50A50-288 module in it. The error code I'm getting is "one flash." It says this is "Lockout - check furnace." Yep, furnace is still there... what am I SPECIFICALLY to check? Any suggestions?
My heater isn't blowing warm air. It doesn't appear to be igniting. What is the normal voltage output of the igniter wire?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
