Ask Experts Questions for FREE Help !
Ask
    mike536's Avatar
    mike536 Posts: 17, Reputation: 1
    New Member
    		  
    #1

    Nov 7, 2015, 07:38 AM
    Hooking portable generator to well pump
    Can I take the wire 10/3 wire that comes from my well pump -- put a plug on it and run it off my portable generator
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Nov 7, 2015, 09:42 AM
    Please do not double post. Answered on your second post.
    mike536's Avatar
    mike536 Posts: 17, Reputation: 1
    New Member
    		  
    #3

    Nov 7, 2015, 09:50 AM
    Sorry just wasn't sure what section to post in. Won't happen again
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hooking up a portable dishwasher to a 3/4" garden hose spigot [ 8 Answers ]

I've got a doosy... (hopefully it's easier than I've made it). Years ago I installed a portable dishwasher in my kitchen using a 3/4" garden hose spigot because the quick-disconnect that came with the dishwasher had a 3/4" garden hose thread. A few years ago I was forced to buy a new portable...

Portable generator [ 1 Answers ]

Looking to buy Westinghouse 8500 watt generator for emergency power. Is this a good generator?

Hooking up a portable dishwasher [ 3 Answers ]

How can I hook up my portable washer permanently?

Portable generator [ 1 Answers ]

I have a 4500 watt portable generator .when I plug something into it it doesn't seem to give that appliance full power,such as lights will be somewhat dim and flicker , not boldly but a flicker nonetheless. Engine runs smooth, but notice the needle on the meter won't quite go up to 120v and it has...

Portable generator [ 2 Answers ]

QUOTE=tkrussell]The 100 volts is a bit low. Electrical device operate on +/- 10% , so the lowest volts supplied should be no lower than 108 volts. Incandescent lamps and electric heat will work fine on 100 volts. But any motors may overheat using 100 volts. Volts is usually changed on the...

View more questions Search