Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Normal bend versus long bend
[ 3 Answers ]
I'm replacing 3”copper drain pipe with 3” PVC. The horizontal run is appx. five feet (toilets,sinks) then transitions to a vertical run, then another horizontal to the sewer. I was originally going to use 90 degree long throw bends at both transition points, then I was told a normal throw/bend is...
We live on an older farm , the toilets rarely flush efficiently 2nd flush is required
[ 2 Answers ]
I liv
Battery operated flush urinal won't flush
[ 0 Answers ]
Battery operated flush urinal won't flush after installing new flush valve. Old flush valve had a small break in the bottom of the flush tube. After installing new flush valve it operated fine for 2 days. Then you could hear the flush motor run but no water would come through. Took apart, didn't...
I have a lead bend that is flush with the floor. A remove a little of the concrete ar
[ 1 Answers ]
Around the perimeter of the bend to set the flange into. It give me just a little space to bend over the flange, not much. Do I need to solder it to make it air tight. How do I solder the bend onto the flange without affecting the lead bend which is embedded several inches of concrete. View more questions Search
|