Ask Experts Questions for FREE Help !
Ask
    mmallow3's Avatar
    mmallow3 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 5, 2015, 07:29 AM
    Gmp075-3 ignitor glows but won't lite
    Ignitor glows but won't lite pressure switch? Main gas valve?
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
     
    #2

    Jan 5, 2015, 09:15 AM
    Pressure switch OK, could be the gas valve.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Electronic ignitor stays lit all the time on Goodman GMP075-4 [ 3 Answers ]

My electronic ignitor stays on all the time on my Goodman GMP075-4. Even when the a/c is running the ignitor glows hot. As long as there is power to the unit it stays on. Before I change the circuit board could it be anything else?

Theem 21vp50-1 ignitor glows but main burner does not ignite [ 3 Answers ]

Hi, I have a 50 gal Rheem PwerVent gas water heater (Model # 21VP50-1) which has started to act up. In past two months, I had to switch hot water heater off and on every few days in order for the main burner to ignite and have hot water. Since yesterday, however, that does no longer work - The...

Ignitor glows and stalls before calling for gas [ 1 Answers ]

Thermostat Calls for heat, inducer runs, ignitor starts to glow, but then it stops, then tries again and again while a clicking sound keeps happening each time it starts to glow. Eventually glows long enough to call for gas and all is normal until next cycle, where process happens all over again. ...

Goodman GMP075-3 gas funace repeated ignitor failure [ 2 Answers ]

Changed !st ignitor in 07 replaced it with a rheem replacement part. Ignitor has failed again. Have had 2 more burn up 3 to 4 seconds after turning red. What should amperage be for ignitor on startup

Furnace ignitor glows but burners doesn't light [ 1 Answers ]

Hi, I have an older York furnace and just replace the ignitor with a Honeywell glowfly universal ignitor. At first, it glows but no ignition... after a while, the burners finally lit and the furnace seemed to work fine with the furnace going on and off. After a few hours, ignitor glows but the...


View more questions Search