Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Leaking hot water heater drain valve after new brass valve installed
[ 2 Answers ]
I had a leaking (plastic) drain valve on my GE hot water heater. It was leaking from the inside of the valve. The small rubber washer was crimped. I installed a new brass drain valve that I purchased from home depot using teflon tape. The valve now leaks from the threads of the tank/valve. I...
Thermal expansion valve on a heat pump
[ 0 Answers ]
I have been having trouble with our Armstrong heat pump. It will run fine for awhile and then I will come home from work and it will be 80° (or warmer) in the house (thermostat is set @ 73°). After several service calls from 2 different repair companies (we have added a hard start kit, replaced...
Leaking hot water shutoff valve in off position
[ 1 Answers ]
Under kitchen sink - leaking hot water shutoff valve (open position) - it seems to be from packing nut. When I try turning off the valve - it leaks and sparys the wall behind.
Supply line leaking at comp fitting on sink shutoff valve
[ 5 Answers ]
I'm using the armored flexible water supply lines for my kitchen sink's faucet. The 3/8 fitting attached to the cold water shut-off valve under the sink is dripping. The flex hose's 3/8 connection end has a rubber washer inside the nut that comes into contact with the face of the compression nipple...
Thermal Expansion Valve replacement
[ 19 Answers ]
I have a 2 1/2 ton Rheem heat pump and I need to know if the Thermal expansion valve can be disassembled or do you have to unsolder and replace the whole unit? The model # on the A coil is RCOB-C0305 serial number is M3292. It appears to me that the round portion that the bulb sensor goes into will... View more questions Search
|