 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Is there a flame sensor on a bdp central heater (1985)?
I have an electric lighter with some wires on it. The heater goes through all the pre-steps to lighting up to lighting up the chamber... then shuts off. Central fan goes on to clear the unit and then it starts all over. If this is a flame sensor on the pilot light should I try and clean it?
|
||||
Check out some similar questions!
Hot water heater flame sensor
[ 6 Answers ]
A.o.smith hot water heater flame sensor
On a 1990's vintage Lennox gas heater, how do I clean the flame sensor? The furnace
[ 0 Answers ]
Operates intermittently, it starts up, heats for several minutes, then shuts off. Doesn't seem to be reaching full temperature either.
Flame sensor
[ 1 Answers ]
What are some symptoms of a flame sensor that needs cleaning or replacing?
How do I change filter on BDP day & night heater?
[ 1 Answers ]
I moved into a new house and can't see where the filter goes on the heater. There is a Honeywell Air Cleaner next to the heater. Any suggestions?
Flame sensor
[ 1 Answers ]
I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
