Ask Experts Questions for FREE Help !
Ask
    yankee23's Avatar
    yankee23 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 8, 2007, 08:19 AM
    Furnace won't come on
    Hi, I'm sure you get a lot of these. I replaced the Thermalcoupling, the pilot lights and the fan comes on when I push it in manual. It just runs and does not start. Any clues? Thanks, Bill
    RalphS's Avatar
    RalphS Posts: 120, Reputation: 12
    Junior Member
    		  
    #2

    Apr 9, 2007, 05:29 PM
    Yankee23, try the Heating & Air Conditioning forum!
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #3

    Apr 9, 2007, 06:52 PM
    I have asked to have your question moved to Heating and Air Conditioning. Some of the people there are very good and have helped many home owners like you.

    Read the sticky in the heating forum, https://www.askmehelpdesk.com/heatin...ons-58313.html It is a great resource that must have taken a good man a long time to prepare. See checking to see if it is the thermostat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring a furnace thermostat to manually operate the furnace fan [ 2 Answers ]

I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

My intertherm furnace pilot lights but furnace won't kick on [ 5 Answers ]

I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH...

Furnace [ 2 Answers ]

My furnace keeps shutting off and blowing cold air and then goes into ignition lock for 3 hours and it blows cold air into the house which makes it quite cold, how do I repair the problem?

Comfortmaker Furnace Fan blows in line fuse and will not allow furnace to work [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...

View more questions Search