Ask Experts Questions for FREE Help !
Ask
    evemarrs's Avatar
    evemarrs Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Sep 10, 2014, 08:47 AM
    Where are the motor bearings model # 10-E24-1B Day night furnace
    I need to oil the motor bearings on my10-e24-1b day night elect furnace
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Sep 10, 2014, 09:05 AM
    How old is the furnace? Newer furnace motor's have sealed bearings and can't be oiled.
    evemarrs's Avatar
    evemarrs Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Sep 10, 2014, 09:24 AM
    Its got to be about 1970
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #4

    Sep 10, 2014, 09:31 AM
    WOW! Over 40 years old. Is this a gas furnace? On most unit's the blower section would have to be removed for access.
    evemarrs's Avatar
    evemarrs Posts: 3, Reputation: 1
    New Member
    		  
    #5

    Sep 10, 2014, 09:36 AM
    The blower case states I need to oil the motor bearings... but it seems like I would have to remove the whole thing.. perplexed.. it started squeeling..this is elect
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #6

    Sep 10, 2014, 10:02 AM
    Yea the blower section is probably original, but I'll bet the motor is newer. You could spray some WD 40 in there and see if that stop's the squealing. Check to see if the motor is screwed down tightly. It could be the blower wheel is rubbing the housing.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Day and night furnace model 383KAV [ 0 Answers ]

I have a furnace that when calling for heat the inducer motor starts to spin but shuts back off immediately. I have to turn the thermostat heat off and back on several times before everything works correctly and starts heating. I did the test on the circuit board module and the inducer motor turned...

1969 electrical diagram for mod. 10-E24-1B day&night central heat unit [ 0 Answers ]

Need 1969 wiring schematic for model 10-E24-1B electric furnace made by Day&Night. Need to replace the heat relay.

Day and night furnace model numbers [ 1 Answers ]

I'm trying to find age of my unit. Model 100 u 19A SN LEGGA 45914

Bdp day & night furnace model #394jaw036065 [ 0 Answers ]

The blower fan won't shut off unless you push the door switch. Blows cold air, fan never shuts off Any Ideas? Should I replace the high limit switch and circuit board? I have found the parts online and also found a Digital Circuit Board upgrade raising the cost from $70.00 to $148.00. Is it...

Can blower motor speed be adjusted on a Day and Night furnace ? [ 1 Answers ]

I have a Day and Night up flow furnace, about 13 years old. Can the blower motor speed be adjusted to a slower speed ? There is only 8 feet of duct and the noise coming out of the registers is very loud. Model # 395CAV036055 66,000 BTU Blower # 511, 1/3 hp If no one has any info, does...

View more questions Search