Ask Experts Questions for FREE Help !
Ask
    Craigsherman's Avatar
    Craigsherman Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 23, 2014, 10:38 AM
    D609G troy built , how to remove rear tires
    How do you remove the rear tire on the D609G Troy built lawn tractor?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 23, 2014, 08:53 PM
    Hi,
    That is an incomplete model number; it should start with 13 and a letter, end with one of the Troy-Bilt vendor numbers like 078. At any rate it is a 600 series frame, i.e. 609 and has a 42" deck, the G. If you mean wheel removal, it is either a bolt or an E-clip covered by a hubcap of sorts. If you speak of the tire from the rim, then you need to deflate it by removing the valve stem core, breaking the bead loose from the edge of the rim and pry one side of the tire over the rim while simultaneously pushing the opposite side downward so that it goes into the recess in the wheel that allows you to be able to pry the other side off.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bad ABS sensor causes rear tires to wear prematurely [ 9 Answers ]

Last summer I went through new rear tires in 5000 miles. No lite or codes came up. Dealer could not find problem. Tire manf. Replaced tires. After watching tires for three months it was determined that tires were still wearing too fast. Finally dealer checked again with ford and changed the...

I have a 25hp 48in cut huskee tractor need how to remove rear tires [ 0 Answers ]

I need to know how to remove the tire off from a 25 hp 46 in cut huskee riding tractor. I removed the black cap and bolt with washers but wheel still won't come off.Please advise.

Rear tires need alignment [ 3 Answers ]

While the mechanic was working on my 2003 Toyota echo. He told me my Rear tires needed replacing. Also the rear tires were wearing unevenly and I Needed a rear end alignment. I did not know the rear gets aligned . Does it have the same camber and castor Adjustments like the front end??

Repair troy built [ 1 Answers ]

Troy built model 556- lost ability to engage self propelled feature. The cable is fine I took apart the housing attached to the handle and need to close it up . Are there any diagrams that will show me the correct way to place the line within the housing

View more questions Search