Ask Experts Questions for FREE Help !
Ask
    lorynsdad7's Avatar
    lorynsdad7 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 19, 2014, 10:00 AM
    Rheem control board has power but OK light doesn't come on or fan motor
    My rheem control board has power coming to it the light lights up but the fan motor or the OK light doesn't light up.do you think I got a bad control board?
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Aug 19, 2014, 10:19 AM
    I wouldn't jump to that conclusion yet. Some testing should be done before replacing the board. If you have a voltmeter and model number, we might be able to help.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem criterion gas furnace control board [ 0 Answers ]

Control board I replaced was from a Rheem criterion gas furn model number is RGDG 10eamer or CW 5D302 - F0294 7885 The board replaced was Honeywell MPLS MN 55422 24v 60hz Called wholesaler said that number didn't make sense long story short that board number no longer used phased out , heard...

I need the part #s for my rheem a/c condenser fan motor and fan blade and fan grill [ 1 Answers ]

Hi I need to know the parts #S of my rheem a/c condenser unit for the fan motor and fan blade and fan grill? Model # is ralc-g4zjaz

Ceiling fan remote to dim light from motor control [ 8 Answers ]

We wired a new light into the dining room. The previous fixture was a fan with a pull chain which we replaced with a fancy three bulb chandelier fixture. The circuit has no switch just wired direct to the ceiling box. We bought a fan remote to install between the box and the light (with no fan)...

Control board rheem furnace [ 1 Answers ]

We purchased a new controlboard for our rheem furnace but it is not exactly the same and the wiring diagram is not matching up like the old one, for instance with the old one the heat and cold wires are black and blue on the new one the diagram says balck and red. Why is it different, and is there...

Board on furnace doesn't light up, no power to heating/ac [ 1 Answers ]

So the dog chewed through the control wires from the heating unit to the condenser outside. I have replaced those wires. BUT now the board on the heating unit in the garage seems to not have power. I am guessing this because the board usually has a red light on when it's plugged in, but it's not on...

View more questions Search