Ask Experts Questions for FREE Help !
Ask
    Rhailey's Avatar
    Rhailey Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 12, 2014, 07:52 PM
    I put my Troy built bronco into reverse while the mower was going it now want go
    I put my Troy built bronco in reverse wihile mower was going. It shut off and now will not forward or reverse
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Aug 14, 2014, 08:45 PM
    Hi,
    Does the clutch feel a bit more difficult to push than in the past? What happens with Transmatic drive sysems (variable speed) is that they can jam or stick when they stop without the clutch being depressed. Cure is to crank engine, put in neutral, select the highest speed on the speed range control, let out clutch until you hear the system whirring under the mower, push in clutch, select forward or reverse and desired speed and release the clutch.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troy built bronco mower, throwing drive belt [ 1 Answers ]

I have a Bronco and any time I drive at a high rpm it throws the top belt. I replaced the belt when I noticed a chunk missing thinking that was the problem but it continues to throw the belt. Only happens at high rpm when pedal is fully engaged. Any suggestions?

Electrical wiring diagram for a Troy Built 42" Bronco riding mower [ 8 Answers ]

Just a quick question.

Troy built [bronco] riding mower [ 1 Answers ]

I recently bought a tbriding mower.It has a bad vibration when you mash on the pedal to move forward.Even when you shut motor off its has a rattle about it. Is any of this normal for the troy built?

I need to put a new belt on my mower deck. It is a troy bilt super bronco. [ 4 Answers ]

I need to run a new belt on my mower deck. It is a troy bilt super bronco with a 42" deck.

Troy Built Bronco 42" [ 1 Answers ]

I have been experiencing my stearing getting sloppy for a while now. I looked at the stearing shaft and it seems tight but noticed that the shaft seems to be missing a bearing at the lower end or the bearing is shot... I was looking at the lower end of the stearing shaft, and it engauges the gear...

View more questions Search