Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Leaky fitting on cold water inlet on hot water heater
[ 1 Answers ]
I recently replaced my hot water heater. THe new one was taller than the old one so I had to cut the pipes and shorten them. I had to use solder on fitting with a brass nut on the top end and a male fitting on the bottom. I have a leak right at the joint and have tried teflon tape, "pipe dope" and...
Leaky water heater relief valve.
[ 4 Answers ]
I had a new 75 gal water heater installed, and have had problems with it leaking from the pressure relief valve, called the installer back, he installed a pressure relief tank, still it leaked, he came back and adjusted the pressure valve installed on the water line by where the water comes into...
New water heater, leaky pressure valve
[ 4 Answers ]
I installed a new water heater and the pop off or pressure valve is leaking a small stream of water. Can this be stopped without installing a new valve?
Leaky Water Heater
[ 2 Answers ]
I have an electric water heater (STATE SELECT) approx 10+/- yrs old. It recently started leaking slowly from the bottom. The leak is not continuous. The unit has not been moved, banged... since it was installed. Any suggestions on stopping the leak other than replacing the unit?
How to repair a leaky cpvc water line under the sink
[ 1 Answers ]
Don't think joints of line have any threads, looks like a coupling just fits over the pipes. Help.l View more questions Search
|