Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I have multiple light fixtures on one switch
[ 3 Answers ]
Hey everyone, I had a house built about 2 years ago and there is one thing that has been bugging me. We have 4 light fixtures run to one switch. Without ripping apart my house, is there and easy way so the first fixture is on it's own, and the other 3 are controlled by one switch! Thank you!...
Replaced light switch and now other fixtures quit working, what did I do wrong?
[ 3 Answers ]
Replaced light switch in the bedroom, light works in room but it is tied to one breaker which operates the bedroom light, the kitchen light, the porch light and one outlet in the kitchen. The bedroom light works where I replaced the switch but now the other items on the breaker do not work. What...
One Switch, 4 light fixtures
[ 5 Answers ]
Ok, I've read all the posts, I think this one is a good one... I have one switch, and 4 lights. Every time I flip the switch, I trip the breaker. Here is my diagram: --b-----sw------+-------+-------+-------+ ---------------------------------------------Ground --w------------- - ------ -...
Adding new light fixtures to existing switch
[ 4 Answers ]
I am trying to add 3 pendant lights to the same switch as a light in the room. The power source runs to the light first, then to the switch. I tapped into the wire from the switch to the light. I connected whites to whites, blacks to blacks, and grounds to grounds. Now the pre-existing light...
Seal draft in and around outlet and light-switch fixtures?
[ 5 Answers ]
I am finishing a downstairs room. The exterior walls are wrapped and sided on the outside, insulated in the wall cavity, and the drywall is pretty well sealed. I am in Wyoming where it gets quite cold. I can feel a draft around the box (gap to drywall) as well as into the box itself. I think... View more questions Search
|