I have a luxaire model pbkm-ld12n080g gas furnace I want the fan to run on high, how

Plutag Posts: 1, Reputation: 1

New Member

Jul 3, 2014, 04:18 PM

I have a luxaire model pbkm-ld12n080g gas furnace I want the fan to run on high, how

How do I change fan speed?

ma0641 Posts: 15,675, Reputation: 1012

Uber Member

Jul 3, 2014, 05:49 PM

You need to look at the control panel and wiring diagram on the motor. It will tell you the different combinations.

Add your answer here.

Check out some similar questions!

Bryant gas furnace model 383 KAV sometimes does not run [ 6 Answers ]

I have a 10 year old Bryant gas furnace model 383 KAV that sometimes does not run. The inducer motor does not come on and there are no codes. If I cycle the power several times it will eventually all work normally at least until the next morning when it may or may not restart after being off at...

My natural gas furnace model mmha-070abhr-01 won't run? [ 0 Answers ]

Is there a pilot light on model mmha-070aahr-01?

Luxaire High Eficiency Gas furnace Pilot goes off [ 8 Answers ]

Hello Experts, I am a new member of this group from New Jersey. I have a Luxaire Gas Furnace about 12 years old. Today all of sudden cold air was coming through the ducts. Blower was on but no flame I saw then turned off the blower and turned on again Pilot came on so did the...

Why does my gas-furnace not run? (fan-blower won't start) [ 4 Answers ]

Hi Why does my gas-furnace not run? (fan-blower won't start) I could not see any blown fuses or circuit-breakers; power-switch is on; I ignited the pilot-light and turned the temp to 90 in thermostat - but fan-blower did not start at all, even after waiting for 10 min; I measured voltage at fan...

GMC Gas Furnace Fan Won't Run [ 3 Answers ]

Hi, I have a friend with a GMC gas furnace that will not start. We are receiving a three blinking LED code that says pressure switch failed to close. We found this switch on the main air fan and discovered the fan will not run in auto or manual. We checked for 120 VAC output on the circuit board...