Ask Experts Questions for FREE Help !
Ask
    dunnb4's Avatar
    dunnb4 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 2, 2014, 11:59 AM
    Honeywell temp trol 2 zone damper control wiring to honeywell RTH9580WF
    Honeywell temp trol 2 zone damper control wiring to honeywell RTH9580WF smart thermostat. I have too many wires at the thermostat not enough terminals. I read on other thermostats with same 2 zone damper control, that if you jump 2 wires together and land them on t stsat it works? I don't know what wires to put together and where to land them?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jul 2, 2014, 12:57 PM
    The control panel for the zone controller does the switching. Panel should show wiring.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell thermostats/Trol A Temp/chronothern 111 [ 1 Answers ]

Heat will not shut off. We have three zones. Switched main one with another and it seemed to work although the battery holders are broken and had to tape the batteries in . What thermostat would be compattible with this one?

Where can I get a trol a temp motor and damper size 8"x14" in the Boston area [ 0 Answers ]

I would like to replace this part

Honeywell Zone Control Panel [ 1 Answers ]

I'm installing an additional transformer to power the zone control panel & dampers. Can I just "tie" into the existing 120 power supply that is connected to a shut off switch that is attached to the furnace?

Honeywell zone control system [ 1 Answers ]

I'm installing a Honewell zone control system (Honeywell HZ311K 1 Heat / 1 Cool TrueZONE Zoning Kit). The kit comes with a low volt transformer, but my existing furnace has an onboard transformer wired into it. Do I need to install the second transformer just to be able to run the control panel...

Replacing Honeywell T8411R with Honeywell RTH7500 - wiring problems [ 1 Answers ]

I need help getting my new, programmable thermostat to work. I currently have a dual-stage Heat Pump and A/C unit that works fine. The current thermostat is the Honeywell T8411R. I don't know the number for the subbase, but it's the one that came with the thermostat. The current (operational)...

View more questions Search