Ask Experts Questions for FREE Help !
Ask
    riksta99's Avatar
    riksta99 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 21, 2014, 11:11 PM
    Prospective Fault Current
    [FONT=Times New Roman][SIZE=3][COLOR=#000000][/COLOR][/SIZE][/FONT][SIZE=3][FONT=Arial][COLOR=#000000]If you were on site and the MainSwitchboard was approximately 15 metres from a 1000 k VA 230/400 volttransformer with 5 percent impedance, [/COLOR]how[COLOR=#000000] would you be able to determine theapproximate prospective short circuit current at the line side of the main switchon that switchboard? [/COLOR][/FONT][/SIZE]
    [FONT=Times New Roman][SIZE=3][COLOR=#000000][/COLOR][/SIZE][/FONT]
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Jun 22, 2014, 12:38 PM
    You might consider doing your own schoolwork and tell us your conclusion so we can assist you. You learn nothing if ẃe tell you the answer.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Constant blower fault & coil fault messages in Nordyne modulating furnace [ 2 Answers ]

We have continuous blower fault errors messages on IQDrive thermostadt and if we go to furnace, turn off... wait a few min... then turn back on... message Clears, furnace blower will start again and will be OK for about 2 weeks and then same error. Intermixed with this periodically are coil...

My york furnace is reading a fault #9(Grounding or reverse polarity fault)? [ 0 Answers ]

My furnace is reading a #9 fault, which the legend says it's a grounding or reverse polarity fault. I have power in, 120V at the transformer as well as 24V, there is a call for heat and 24V at the R & W terminals. Is there any input anyone can offer me? Thank you.

Fault Current At Commercial Main Service [ 4 Answers ]

Here's a weird one. I have a tenant with a 150A, 3-Phase, 480V service. The main switchboard is in the basement and the breaker panel is located in the tennant's space 50 feet away. There is also a 120/208 panel board next to the 277/480 volt panel in the same closet. The step-down transformer is...

Short circuit current fault [ 1 Answers ]

I have quite a simple system. Contains one substation, feeder pillar and 3 houses. I have calculated the short circuit current that the transfromer in the substation can deliver but is there any one that can help me with finding the equations to calculate the short circuit current level supplied by...

View more questions Search