[Jutta Myers]

Spent the last 2 days on the comp. trying to figure out to reset a dishwasher.On My Kenmore ultrawash 665 17779990 the cancel/drain light is on. All button do NOT work to let me run a washcycle HELP Thank you from Florida

[ma0641]

Turn off the breaker that controls the DW. Let it sit 5 minutes and flip breaker back on. See if this clears the codes.

[Jutta Myers]

Did that many times. NO luck THANKS

[drtom4444]

Try this:
Heated Dry, Hi Temp Wash, Heated Dry, Hi Temp Wash, Close the door, Start, open the door, Cancel 2x , or:
1. Press "Normal Wash" and "Heated Dry" one after each other about five times.
2. All lights on panel will light up. Wait until all lights go out and it resets itself. It will go through a test mode.
3. Press "Cancel" and set as you normally would and press Start.
(Originally posted by curtisst.
If the above does not work, do this: (From another post here)
"1. Unlock your Kenmore dishwasher control panel by pressing and holding the "Heated Dry" button for four seconds.
2. Press a series of four buttons in quick succession. Press "Heated Dry,""Normal Wash," "Heated Dry" and "Normal Wash" to instruct your Kenmore dishwasher to run a short diagnostic test.
3. Wait for two minutes while your Kenmore dishwasher runs its diagnostic test.
4. Press the "Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel and stop the "Clean" light from blinking repeatedly."
I hope that this helps. Here are a few documents that should help: https://dl.dropboxusercontent.com/u/...Dishwasher.pdf
https://dl.dropboxusercontent.com/u/...t%20Codes.docx
https://dl.dropboxusercontent.com/u/...ishwashers.zip
Make sure to check any safeties such as the high-water-cutout float on the bottom of the tub and anything else suggested in the manual that could be tested with a meter if the above does not help.

[Jutta Myers]

Thank you for your reply.DID try everything ( again) and - nothing worked. Do NOT have heated dry button.. Cancel /drain light still on and no other buttons work. My Panel = pots pans/normal wash/watermiser/chinawash/quick rinse/waterheat/no heat dry/delay hours/start/cancel/drain.can NOT open the 3 manuals you sent me. I have Kenmore ultrawash 665 17779990 Thanks again frustrated in Florida

[drtom4444]

Install Magic Disk by clicking on this link: https://dl.dropboxusercontent.com/u/..._magicdisc.exe, downloading, and after you download double-click on the file to install. Then click on other links to download. To open zipped files right click on them and choose "Extract Here" and it will unzip the files.

[drtom4444]

Here is a Kenmore Ultrawash manual: https://dl.dropboxusercontent.com/u/...Dishwasher.pdf

You could have a safety tripped, if so there is no way to reset it without fixing the problem. Look for a stuck float switch or door switch.

[Jutta Myers]

Thank you again fro trying to help me. I guess I have to call the service people