 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Copeland condenser fan motor
Ok I am replacing a condenser fan motor for a home unit. It has been replaced before about 2 years ago. It's a dual cap system. It has a new cap with the new motor. Here is my problem. The motor has 5 wires white, red, black, brown, brown/white. When it came apart I did not see where the white wire went. The black and red where wire nuted to an original connector. The white might have been tied to the red I just didn't see it. I need some help figuring out where the wires go. I think this is how it should go. Black T1 White T2 brwn and brwn/wht to cap. Red is low speed and not used. I don't think it should have been connected to the line. Can anyone tell me if this is correct?
|
||||
Check out some similar questions!
Hi I need to know the parts #S of my rheem a/c condenser unit for the fan motor and fan blade and fan grill? Model # is ralc-g4zjaz
Motor has four wires yellow, black, brown, and brown with white sripe. The od motor only had three wires black,red and brown. On the new motor I hooked the yellow to L1 the black to L2 and the two brown to fan on the dual cap. The motor starts, runs but it gets very hot and shuts off after a few...
I have a Rheem a/c unit that the fan motor quit. I took all the information off the old motor and went to a local supply store and they cross-referenced the numbers and gave me and Emerson motor. All the specs are the same, 1/5 HP, 1075 RPM, 60 Hz, 1.3 Amp, single phase. When I got home, I took...
The Condenser fan motor I removed from a Trane unit had four wires 1 black, 1red, 1brown and . The black wire went directly to #3 on the relay, the red wire went to the capacitor with black wire from #6 on the relay the brown wire went alone to the other side of the capacitor. I purchased...
Hi my unit is a Rheem the condenser condenser fan is making a hooming noise like is a turbine not a fan I wounder if the blades or the contactor making that noise the fan that I had was a original from the manifactory but it was stoping went it got to temperature well I replaced it with one that...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
