Ask Experts Questions for FREE Help !
Ask
    dawnclaney's Avatar
    dawnclaney Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 9, 2014, 01:36 PM
    Kenmore dryer 110 won't heat
    I have a Kenmore 110 electric dryer that runs but doesn't heat on any cycle or temperature setting. I have checked the breaker, voltage, heating element, thermal cutoff and thermistor. I have bypassed heat relay and ran diagostics. All checked out. I figured it must be the control panel so I replaced it and it heated for about 2 minutes and now it doesn't heat at all again. Everything works except there is no heat. Not sure how to check centrifugal switch or if that could even be the problem. Please help.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    May 10, 2014, 07:00 AM
    It sounds like you have a grounded hot wire or a short somewhere. The only way to find it is to start at the plug and work your way through the wiring in the dryer until you find it. Here are some manuals: https://dl.dropboxusercontent.com/u/...l%20Dryers.zip
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore dryer (110.698129900) won't heat up. [ 0 Answers ]

Kenmore dryer (110.698129900) won't heat up.

Kenmore dryer 110 66822692 won't heat [ 1 Answers ]

I've checked the breakers. Now I want to check the heating coil with an ohms meter. What's the best way to do this?

Kenmore 110 series dryer won't heat [ 1 Answers ]

I have a Kenmore 110.86870100 electric dryer. It won't heat and dry. We have already changed the heat element as it was bad (broken wires) but it still won't heat up, not sure what else to check.

Kenmore dryer 110.66942500 won't heat [ 1 Answers ]

I have a Kenmore elite dryer (110.66942500) that won't heat. Everything else is working, the ducts are clean. I thing is the heater element, what can I do to check and how to replace it if bad. Thanks.

View more questions Search