Ask Experts Questions for FREE Help !
Ask
    Vaha's Avatar
    Vaha Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 4, 2014, 02:41 PM
    Kohler K-404 thermo valve stops working how to fix it
    Kohler thermo valve K-404 stops working how to fix it??
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
    		  
    #2

    May 4, 2014, 03:16 PM
    Hi Vaha

    Here is a troubleshooting guide...check it out:

    http://www.ca.kohler.com/onlinecatal.../1021063_5.pdf

    Disassemble the valve, purge it of sediment/gunk, inspect all inner parts and replace if needed. Reinstall parts and test.

    Good luck!

    Mark
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to fix ac thermo control amp on a 2000 altima [ 0 Answers ]

How locate the thermo amp control on a 2000 nissan altima

I have a early 90's Kohler shower valve and rounded out the cold stem valve seat. [ 2 Answers ]

Should I drill then retap the threads? Thanks!

InSinkErator Pro 17 stops working and red reset button doesn't fix it anymore [ 3 Answers ]

Our InSinkErator Pro 17 disposer was acting up recently. It would stop grinding and will do this humming noise. First couple of times, resetting the red button on the bottom would fix it. Now, resetting the button doesn't change anything. Moreover, after a few tries the bottom part of the...

New thermo not working right. [ 4 Answers ]

I have a Janitrol HTP 1860 thermostat now. I recently acquired a Honeywell TH6220D. I hooked it up and all seemed to work fine. I turned the ac on tonight and after about 5 inutes noticed it was blowing hot and the unit outside was not on. Turned it off and waited and did it again, this time I...

View more questions Search