Ask Experts Questions for FREE Help !
Ask
    Dustin reynolds's Avatar
    Dustin reynolds Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 10, 2014, 04:35 PM
    95 Chevy 350 tbi
    Recently me and a buddy was using sea foam in my truck vacuum lines we had it running then it died why we were pouring in the sea foam. Now my truck will not start. I'm getting gas, good spark. I change the rotor bug but all it will do is turn over but won't start! Help! 95 Chevy 350 tbi.
    cdad's Avatar
    cdad Posts: 12,700, Reputation: 1438
    Internet Research Expert
    		  
    #2

    Apr 10, 2014, 05:11 PM
    Its possible that you fouled out the plugs. Which vacum line did you use? To use sea foam your suppose to get it in and shut it down but you should have already warmed up the engine to temp. Did you do that?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #3

    Apr 10, 2014, 05:20 PM
    Remove, clean, and dry the plugs. If the engine doesn't start when you reinstall the plugs, try starting fluid.
    Dustin reynolds's Avatar
    Dustin reynolds Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Apr 10, 2014, 05:41 PM
    Used the vacuumed line to the brake booster yes engine was warmed up
    CaptainRich's Avatar
    CaptainRich Posts: 4,492, Reputation: 537
    Cars & Trucks Expert
    		  
    #5

    Apr 11, 2014, 05:19 AM
    Do like Tx said but while the plugs are out, crank the engine BRIEFLY to clear any excess foam from cylinders.
    (Be prepared to make a mess!)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

88 chevy camaro power to one tbi and not the other [ 1 Answers ]

Had to replace my tbi connector because it was broken now I am only getting power to one side and not the other. Not sure how to fix

1979 350 chevy pu [ 3 Answers ]

Hello, here's the situation - The battery cranks over well, the starter is turning, and right when the engine normally fires (2-3 seconds) there is a grinding sound like gears, so I shut it off - what can I do?

Which is better- 350 Ford OR 3500 Chevy [ 2 Answers ]

I am looking to purchase a used truck to haul horses, farm equip, etc. I have noticed far more Fords for sale than Chevy. Are the Ford owners just not satisfied? I know the Ford 6.0 L has had more than its share of warranty claims. For the years of '98 through '02 who produced the most reliable...

1994 350 tbi chevrolet. Soleniod valve which regulates egr vacuum will not open [ 4 Answers ]

I have verified solenoid is good. I have 12 volts to solenoid but the switch that completes circuit is in ecm. I have replaced ecm. My info states that "to close switch 1.the vehicle must be operating temp. 2. throttle above idle 3. MAP" ... any info will be appreciated.

New chevy vortec 5.7 350 [ 2 Answers ]

I have around 800 miles on my new vortec 350 motor so when I go to power brake and smoke the tires I here the lifters knock or a gas ping noise what could cause this.

View more questions Search