Ask Experts Questions for FREE Help !
Ask
    stevearnot's Avatar
    stevearnot Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 9, 2014, 11:06 AM
    YORKgas furnace won't ignite
    Thepropane tank emptied before delivery truck came. After it was refilled, the draft inducer motor ran but the igniter won't come on. York 90 plus furnace control box (WHITE ROGERS 50a50-209) light blinks 3 times. I checked tubes and pressure switch on diaphram. There was a little water in drain tubes. Could igniters be bad? If so how do I check them?
    ( I had run out of gas 2 years ago and the draft inducer motor had to be replaced, but it is still working now.)
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Mar 9, 2014, 11:13 AM
    Draft inducer has nothing to do with propane. What is 3 blink code, it is on the control board on older White Roger boards.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Furnace won't ignite [ 0 Answers ]

Carrier furnace that won't ignite red light flashes 3 times then 1 and repeats

My furnace won't ignite [ 5 Answers ]

I'm trying to find out why my furnace won't ignite. The pilot light is on, I can hear something turn off when I checked the breaker and it came back on when I turned the breaker back on. If I turn the fan to on it works. I'm thinking it's the thermo coupler but I don't know how to test that. ...

Furnace burners ignite but won't stay lit on my trane xe78 furnace? [ 0 Answers ]

I have a Trane XE78 furnace and the flames come on for about 5-10 seconds and then shut off. They re-ignite about 10 seconds later, then shut off 5-10 seconds after the 2nd ignition. I believe they flame on one more time, shut off and then never re-ignite and the blower just runs and runs with...

My Furnace Won't Ignite [ 2 Answers ]

I have a 1980 propane furnace. The pilot light will light. And the heat will kick on after the lighting. But after the furnace gets to the desired teperature the first time, the pilot light goes off and i have to start the process all over again. How do i keep the pilot lit and thereby keep the...

Furnace won't ignite [ 3 Answers ]

I have a Comfortmaker RPJ Heat Exchanger. It won't ignite. I tried the troubleshooting instructions on the unit and it won't work. I remember there was another switch that may have done the trick before but can't locate it. ANy suggestions?


View more questions Search