Ask Experts Questions for FREE Help !
Ask
    pj100's Avatar
    pj100 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 13, 2014, 03:57 PM
    New flywheel for a zxr10000i generator
    Hi I have one of the chinese built supposed honda powered zxr10000i generators which blue a flywheel and am having problems getting the right one to replace it any ideas as to which I should get? The engine numbers are non existent but it is a gx360 model.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Feb 13, 2014, 04:16 PM
    Where and when did you buy it?
    pj100's Avatar
    pj100 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 13, 2014, 04:25 PM
    Off the net around 4 years ago I think
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #4

    Feb 13, 2014, 05:17 PM
    Hi,
    There should be a tag on the side of the engine that is either white or silver with black letters and numbers. Normally it is on the most visible side. Give me those numbers and I will look it up. Also advise if it is electric start; I gather it is, but want to make sure.
    Peace,
    Clarke
    PS Or if you know how to use it, here is the GX390 parts manual attached.
    Attached Images
  1. File Type: pdf Honda GX390 parts.pdf (2.58 MB, 251 views)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Why won't the new starter not move the flywheel when the flywheel will move by hand? [ 3 Answers ]

The flywheel seems to lock up when trying to start.just put new starter in, the motor turns by hand at the flywheel and front of engine. But yet it seems to try and start but just stops with a clunk.there is no teeth missing from flywheel, made sure to check for that also. Can u Help?

Generator wiring: new generator gfci breaker tripping [ 2 Answers ]

Generator wiring: I have a new honda generator. I ran 3 wires from the garage to the transfer switch in the house. When I start up and throw in the breaker on the generator, its GFCI trips immediately. It is a long run (125ft) run to the house and I used heavy wires. But I only ran 3 (blk,...

Connecting Generator to Generator Transformer. [ 0 Answers ]

For connecting 7 MW generator to generator transformer, which is better cable or NSPB ?

I require for a Power Plus 5000 Generator 1 generator under following specifications: [ 1 Answers ]

I require for a Power Plus 5000 Generator 1 generator under following specifications: 5000 Watts, 120V, 1 Phase, 60 Hz at 3600 RPM, 3720 RPM at no-load. Thank you, Publio

How much torque on a flywheel? [ 2 Answers ]

17HP Briggs and Stratton. 42" Murray Mower. How much torque should I use to tighten the flywheel down? Thanks.

View more questions Search