Ask Experts Questions for FREE Help !
Ask
    Kayx5's Avatar
    Kayx5 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 11, 2014, 04:09 PM
    Reset switch for Heil 7000 NUGK100DH12
    Blower stays on even though thermostat is off. Want to try the reset switch. Can't even find an on/off button to try on the furnace.

Check out some similar questions!

1992 Heil 7000 furnace [ 2 Answers ]

Last night I touch two red wires and a part fell of my furnace. I was able to put the part back on but it must be broken to come off that easy. I think it is called a flame rollout switch or sensor. Should this fall away from its location?

Heil 7000 [ 0 Answers ]

The furnace I have is working for the first 2 or 3 startups then the burners rapidly go on and off and won't stay lit. can anyone tell me what to look for and test. Thanks any help is appreciated

HEIL 7000 furnace [ 0 Answers ]

Furnace won't stay lit iv'e tried jumping limits and roll over switches volt meter reads 24 volts what should I do could it be the gas control valve?

7000 Heil Furnace [ 1 Answers ]

My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...

Heil 7000 [ 3 Answers ]

We have a Heil 7000 propane furnace. We had it installed in 1993 and haven't used it much over the years. This year when we started using it the motor had froze up and we replaced that part. Draft/flue inducer. I think is what it was called.Anyway after we reinstalled the part now the ignitors...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.