Ask Experts Questions for FREE Help !
Ask
    manateev's Avatar
    manateev Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 10, 2014, 06:00 PM
    Old tempstar 5kw heat strips
    Where can I get a replacement model PA9536AKA1
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Feb 10, 2014, 07:04 PM
    Have you tried either a Tempstar or Heil dealer? I found a lot of parts here but no heat strips: http://www.searspartsdirect.com/part...Mod=PA9536AKA1

    If you search for that model number you will get a lot of hits.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman gph1324m41 package unit with hkr 5kw heat. Two dedicated 30 amp circuits ? [ 4 Answers ]

Does this Goodman gph1324m41 package rooftop installation require one dedicated 30 amp heat pump circuit with disconnect, and a second dedicated 30 amp circuit with its own disconnect for the HKR 5Kw heat coil. That is two separate circuits from the house panel . Seems like overkill, if the...

Cost? Heat Pump vs Heat Strips VS LP Gas below 20 degrees [ 3 Answers ]

In the climate where I live it is seldom below 20 degrees Fahrenheit. However, we do get a cold spell everynow again, sometimes lasting 3-4 days. I understand a heatpump is less efficient at lower outside temperatures. Below 20 degrees our heatpump runs about 90% of the time. I can raise indoor...

Electrical wiring for tempstar heat strips [ 3 Answers ]

How do you change a 3 phase air handler into a single phase air handler without replacing the air handler?

Minimum Circuit Amps for 2 ton air handler with 5kw heat strip [ 2 Answers ]

Hi all. I currently have a 30Amp breaker on 10 gauge wire for the air handler and heat strip. This was a new install and the local inspector seems to think that 30amps is not enough. I took a picture of the specs and uploaded below. What breaker/wire is needed to be in compliance? Any help is...

Heat strips [ 3 Answers ]

New heat strips were installed on a Goodman package h.p. and the strips were not working. There was 240v going to the strips and 24v to and from the t-stat. What could be the problem?

View more questions Search