Ask Experts Questions for FREE Help !
Ask
    davidanddolores's Avatar
    davidanddolores Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 10, 2014, 03:49 PM
    Need schematic for hp22-461-3p 208/230 volt lennox furnace to be able to identify
    I need a schematic of a Lennox HP22-461-3p Furnace so I can Identify part I need to order. Serial #5193c16067--- 208/230 voltage
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Feb 10, 2014, 07:24 PM
    This may help. http://www.completeheating.ca/manuals/LennoxHP22.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to wire a 208 /230 volt supply for a welder? [ 7 Answers ]

To Whom It May Concern: I need some advice on a 4 3 wire with ground wire; where does the ground wire go on a 208/230 setup? I am using a 50 amp double pole breaker. Sincerely, Tracy G. McDougal [email protected]

Can I get 230 volt from a 120/208 3 phase panel? [ 2 Answers ]

I have a120/208v 3 phase panel and I need to plag a 230v motor ,this it possible?

208 Volt Single phase vs 230 Volt single phase [ 3 Answers ]

I have a commercial appliance that is rated for 230 volt single phase. All I have available is 208 volt single phase. Will the unit work on 208V or do I have a problem?

What kind of ground screw to use for grounding w a 4-6 gauge wire from a 208/230 volt [ 2 Answers ]

I am wiring a receptacle for a millermatic 251 welder that requires 48/42 amps. I am using 4 gauge wire for the two hots. Little overkill but it was gotten for free. I am not sure how to ground the 4-6 gauge wire I plan on using on the receptacle. The typical grounding screw meant to be screwed...

1/6 HP 2-speed 1075 rpm 208/230 volt condenser fan motor wiring diagram [ 2 Answers ]

I am having trouble wiring the condenser fan motor in with capacitor and new contactor on a single phase 240V system. I have no wiring diagrams to go by as this condenser is 20 plus years old. The compressor will fire but I cannot get the fan motor to run even though it's wired off both sides of...

View more questions Search