 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kohler toilet fill valve not functioning
Dear Help Desk:
My old Kohler fill valve fills only half way up to the fill line and then continues to fill very slowly. It appears to be partially blocked and may need to be flushed. It shuts off if I manually keep the float down until the tank is filled. It has two caps held in place by screws, but I hesitate to remove the caps, since I do not have access to replacement parts. Can you tell me if removing one cap and using a cup to cover the opening will that allow the valve to flush or do I have to shut off the water, remove the fill valve and then use a hose to clean it? Ben |
||||
Check out some similar questions!
My toilet tank won't fill with water unless I lightly touch the top of the fill valve on the left hand side of the tank. I have a santa rosa kohler toilet. As soon as I touch it or jiggle it a bit the tank fills up with water and flushes fine but the tank won't refill again. How do I fix this? ...
Hi there, I screwed in a Fluidmaster Universal Toilet Fill Valve into the socket for my pool water fill, but it isn't filling the pool. I do believe I have the correct height. Could it be that the "refill tube" is not attached to anything? There does not seem to be a place for this to attach to...
I have two Kohler 1.6 gal. flush toilets 1 1/2 yrs. Old. They bth just recently started to take excessive time to fill. There is some instructions that say to clean and flush the system but does not tell you how to do it?
I have recently had a soft water installation put in. The shut off valve is conveniently close to the garage where the clean water tank was installed. Anyhow after the installation was completed pressure worked great in every room except the master bathroom toilet. The dual sink, the shower, and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
